Light Up Coaster

Coaster with build in led and printed switch.

No soldering, no gluing, just click together.

All parts printed with 0.4 nozzle and 0.2 layer heigth.

Hardware needed:

Use a 5mm (3V) led. I used color changing leds (clear - slow blinking), see remark on length of leads.

As battery use a CR2032.

For maximum effect use a bright led.

Installing the led and battery:

Different Top Parts added.

Use the blank one for single filament without image. Use translucent or slightly translucent Filament. For remixing all files are added as step-files. The center part in the basic top part is to allow much light in the center for maximum effect.

To change the battery just remove the top and click together again..

I completely forgot to show in the video how the switch works, although it might have been obvious: