Anbernic RG35XX Snap On Case

Print with the flat side against your build plate, supports will not be needed. The case is designed to be used with the foam insert that the RG35XX ships with, I attached mine with a little glue. If you don't have the foam it shipped with, you can use 2mm thick foam available through most major online retailers. 

The case snaps on with plastic nubs, which (at least on my unit) are short enough to slip over the plastic shell, but not poke the connectors inside. The nub on the top is a little wider, it's easiest to slide the RG35XX into the case top first, then pop the bottom on.