ECAS Attachment for 1/2" Conduit

This is an attachment that i designed to compliment the Reprack and Rackroller design to allow for a bowden fitting at the reprack for use with my Enraged Rabbit Carrot Feeder MMU. Below are links to the heat sets and ecas fittings used in the design. As for the bolts, I used 10mm m3 SHCS.

For printing, i used standard Voron Print settings. See attached image for the printing orientation that i used. On my printer i did not have to use supports, but if you choose to print it on its side for more surface area, supports may be required. When printing in the orientation shown, i did slow down the print due to curling on the edges at the overhangs but increased the speed again after it finished bridging.

https://www.fabreeko.com/products/bmg-collet-ecas-pack-of-5?_pos=1&_psq=ecas&_ss=e&_v=1.0

https://www.fabreeko.com/products/threaded-heat-inserts-m3x5x4-100pc-per-bag?_pos=1&_psq=heat&_ss=e&_v=1.0&variant=41024099287238

https://www.printables.com/model/129024-reprack-open-source-spool-holder-and-storage-syste

https://www.printables.com/model/131429-rackroller-open-source-flange-roller-add-on-for-re