Signage Stand
My partner needed these to hold signage at the school. The ones I was modeling after were fragile and mostly destroyed.
3
18
0
71
updated February 9, 2024
Description
PDFI printed mine at .28mm. I printed with both my .4 and .8 nozzles and they printed about the same grip on paper. the .4 was a bit stronger…I think.
In the photos you can see the 2 new designs (sloped sides and 2 top layers. The right is the old design. No slope and only 1 top layer.
The model has the teeth overlapping. This is because when you slice them you will get a slight gap. If I design it with the gap, it prints much larger. This is due to print resolution.
I included step, f3d, and 3mf files.
.28 mm (on .4 or .8 nozzle)
No supports
No rafts
No brim needed
1 bottom layer
2 top layers
15% infill (grid)
Tags
Model origin
The author marked this model as their own original creation.
