Ski Carry Clips V3

I really need this because I carry my skis 2 km to get to where I can put them on to ski. The clips hold the skis and poles together so I am just carrying one awkward thing instead of four awkward things. Its a little fidgety to put together, but works nicely.

I used 4 perimeters, and top and bottom layers, 15% gyroid infill, PETG.

From auban's original post (mostly):

The Fusion model has parameters so that you can easily change it to fit your poles and skies. Just take the measurements for width of the skies, the thickness when two skies are held together and the diameter of the poles. Also change the text so that the clips can be put on the correct skis. Other measurements can of course also be changed, like the distance between the skies and the poles and everything else.

The model is remixed from this: https://www.thingiverse.com/thing:3326869
Which in turn is based on this: https://www.thingiverse.com/thing:2729641
Which is based on this: https://www.thingiverse.com/thing:233003

And the original inspiration is from: http://www.klipski.fr/?page=&id=&lang=GB

I did a remix because, in my humble opinion, the original model is detailed for injection molding not 3d printing. Injection molding requires a relatively constant thickness, while 3d printing does not. If you look at what I did, I got rid of the internal voids and instead used a low infill, but made the sides thicker at the back corner where the stress is the highest. I sliced both designs and my remix takes less time to print because infill is printed faster than perimeters, and uses the same amount of filament (I used the same settings to compare the two models). I also added fillets to the top and chamfered the bottom for a nicer feel.