Wera Gridfinity Screwdriver Rack 1x2 anti-Wobble

Screwdriver rack for up to 8 Wera micro screwdrivers. The new base allows for some additional stability. Shortening the legs doesn't work for sets where there is a lot of length variability in the screwdrivers.

Per original maker:

When printing the legs, rotate them so the flat part is facing the bed. e.g. 45° on Z axis, 90° on Y axis. No supports are needed.

There are no tolerances built into the design, so fitting the legs takes some work. Use a sandpaper or a file on the stubs to make it easier.  *I've been able to tap the legs into place without any sanding. The fitment eliminates the need for glue in the model.

This is an additional base that provides additional support to keep the screwdrivers even more stable. This works well in a set of mixed length screwdrivers.