1 inch wide feet for the AMS drawer unit

The AMS drawer stand was slipping and sliding on my printer, so I bought some of these non-slip pads: https://www.amazon.com/dp/B08C373VBW/ and added them to these wider feet. The drawer stand still fit nicely on top of the Bambu Labs X1C with these wider pieces.

No special considerations were needed when printing. Because the pads will flatten some with time, you must replace all 6 feet with the wide foot/pad combo.

I recently decided to upload all of my designs, regardless of how likely I think it is that someone else will be looking for the same thing. I was and am still a novice at openSCAD, so the quality/customization of some of these designs is poor. If you have any specific questions, I will try to help.

These are replacement feet that are wider at the bottom, to allow the use of 1 inch round non-slip pads.