LOC Precision Adjustable Removable Nose Weight System

This system allows you to use the same pieces over and over.  No need for multiple cartridges.

You will need some lead shot or anything that fits inside the compartments and has weight.  I use lead shot in Ziploc bags as seen in the photos.

I added little holes in the parts in order to let air through, so it is easier to put the cylinder into the nose cone.

Required for use:

• Print at least one of the cartridges that are 1 inch, 2inches or 4 inches long
• Print the cartridge anchor
• Get a ¼ inch eye bolt or metric equivalent with washers for both sides and a nut/lock nut

Print settings, 3 perimeters and 30 % infill with 0.2 layer height.

I printed with PLA, but PETG and other materials will work just fine.  Give the cord a few yanks to make sure it holds, and you should be all set.

Video of my Loc Precision 7.6" Phoenix which uses the RNWS.