Galaxy Watch 6 Classic Stand

This stand holds the 43mm "Samsung Galaxy Watch6 Classic" watch and charger.

Press fit the clip to hold the charging cable in place.

I printed the stand upright with no supports. It was a little rough on the inside of the top. I had to clean it up a little to get the charger to snap in. But after that it was all good.

Update 8 Feb 2024
User ThisIsTh3End on Thingiverse has figured out that a stand printed at 115% will hold the 47mm Watch6 Classic. Thanks ThisIsTh3End!

Print Settings

Printer Brand: Prusa

Printer: i3 MK4

Rafts: No

Supports: No

Resolution: 0.2 mm

Infill: 15%

Filament: Prusament PLA Black