Office trash can

Office trash can, it's very cool when you have a waste with the 3d impression.

My vidéo in french 

For this creation i have use a magnet, the magnet is located in the 3d impresssion, for this result you must program a pause in the slicer for place the magnets 

For the hole i have use a hole saw in 110mm but i recommend  use a more big diameter because with 3d part the fit is not good.

• Magnets: 6*2mm
• 20% infill
• Support yes but not automatic because the slicer add a support in place for magnets
• Layer 0,2mm

Print on Ender 3 V3-SE