Odi Handlebar Cap Middle Finger

This is a quick and easy print that instantly makes your bike look way cooler. You simply print the model, either you can change the filament or you can paint the model after it is done. I recommend printing with the hand up, then the ugly side where there are supports wont be seen, dont worry it doesn't impact how well it sits on the bike.

If you want to print it in multicolor and you dont have a fancy AMS then just watch this quick video which helped me a lot so i dont have to watch my print and be worried that i pause at a wrong time.

https://www.youtube.com/watch?v=kkOuyhffNQk&ab_channel=MysticMesh3D

When you have printed the model and you want to put in on your bike then follow these steps:

1. Loosen the outer ring that holds your grips into place.

2. Pry the old cap out. (sometimes you might need a tool if it is stuck)

3. Take your 3D Printed cap and push it in, dont be scared to press hard for it to go in, that is intentional so it wont fall out while biking.

4. When it is sitting on the handlebars then twist it around untill it moves smoothly.

5. Turn it to the direction you want it to (preferrably with the finger up) and then tighten the outer ring of the grip.

6 Go and show it off to your friends.

I could aparrently not add the print file since i modified the gcode to make a pause like he did in the video. Creality cloud accepted it without any problems but Printables aparrently doesnt know the code "M0" so the file couldn't be added, so just follow the video and you will get the same result as me.