QIDI X-MAX 3 material break detector raising bracket.

Disassemble the original material break detector, use the removed screws x 4, and install the fixed lifting bracket.
Use M3x18 x4 (M8x16 can also be used) to lock the broken material detector.

The left handle is inlaid with a spool bracket, model link:https://www.printables.com/model/750704-qidi-x-max-3-handle-inlaid-spool-holder

Need the following:

1. QIDI X-MAX 3 material break detector raising bracket.
2.  M3x18 x4 (M8x16 can also be used).
   https://s.click.aliexpress.com/e/_oBRuvVk
3. 2*4mm PTFE (for 1.75mm Filment) 30 cm.
   High Transparency  2x4mm PTFE Tube：
   https://s.click.aliexpress.com/e/_Dn5Qfxj
   5 Colors 2x4mm PTFE Tube Teflonto ：
   https://s.click.aliexpress.com/e/_Eus1G3x
4. 4PIN Dupont TJC8A 2.54mm Extension Wire Cable Connector (Male to Female) 20cm.
   https://s.click.aliexpress.com/e/_DegcUJr
5. Mini Portable PTFE tube cutter
   https://s.click.aliexpress.com/e/_onABCzC
6. Cut PTFE to a length of 11CM (PTFE tube between extruder and material break detector)
7. The left handle is inlaid with a spool bracket.