Prusa MINI Base Camera holder

The holder fits inside a hole in front left leg in place of original insert. It is a friction fit, no screws for mounting needed.

However you will need a screw to mount the camera. I use Microsoft camera with standard camera screw, so I printed a ¼'' screw from Thingiverse https://www.thingiverse.com/thing:578514

I created the arm in three versions:

90 degree is paralel with front panel. It is best for low overal volume of printer, but IMHO too close to the printed part.
50 degree is my favorite for the most natural angle of view.
70 degree was my first try, it is a compromise between the two.

The camera arm can vibrate, especialy during small and rapid movements, like infill in tight areas. It is not suitable for streaming of online viewing, but for ocasional look via Octoprint or even Octolapse timelapses, it is OK. And IMHO the worst part for vibrations is my camera itself, which has the flexible mount.

This model was a designer chalenge for me, as I don't have so much experience in Fusion360 and remixes. If you have any idea for improvements or need a different mounting for the camera, just let me know.