Added spoon slot to generated printables box

After trying dozens of items on the cuttlery contest, I actually ended up with a wonderful on-line gridfinity generator, thish is based on the OpenSCAD WASM port
I heartily recommend using that generator for any size boxes you need in your kitchen drawer.

You can open my settings in the generator with the included link, but here they are:

• height 8 (Ended up 59mm total height)
• No holes for magnets or screws
• No subdivisions
• No labels or overhangs or fillets
• Outer wall increased to 1,95mm (for better adhesion)
• No lip

I only added a little cubby to store coffee spoons.
But it took me a few tries to get right, so I thought I might as well upload it here.

My print settings, as included in the 3MF file:

• Started with Bambu 0.12mm High Quality Setting
• Quality: Ironing: Top surfaces
• Quality: Ironing Pattern: Concentric
• Quality: Ironing Flow: 16% (the model in the photo was printed with 15%)
• Strength: Wall loops: 6 (not sure if this helps)
• Detect thin wall: yes (not sure if this helps)
• High Temperature (smooth PEI) plate: 60C for PLA, 95 for ABS (5 degrees up from standard)
  • With this, 2 of the furthest outside corned lifted a fraction, all the rest was perfectly adhered.

I tool the generated model and added a little spoon cubby in the side.