Love my Milwaukee Fast back its the knife I carry around with me everyday. I never had much use for the clip attached so I removed it and just installed a bit holder to take its place.
- To start you will need to remove the screw that is holding the clip in place
- Then you will need to install this longer screw #6-32 x 1/4 in. Phillips Fillister Head Zinc Machine Screw (3-Pack) https://www.homedepot.com/p/6-32-x-1-4-in-Phillips-Fillister-Head-Zinc-Machine-Screw-3-Pack-851068/204283511
- Be careful tightening it if your Printing using PLA or other non fixable filaments it can crack
- also when printing you may need to enable supports depending on its orientation in your slicer
Tags
The author marked this model as their own original creation.