LACK table power switch mount

This is just a simple mount for a rocker switch I had (seems to be a common footprint), to fit under the corner of an Ikea LACK table, as might be used for a 3d printer enclosure (https://www.thingiverse.com/thing:2864118).

The "left" one puts the switch in the upper-left corner of the lower of the two tables. The switch just slides in from one side, and is held in place by the table leg.

For the curious, mine cuts into the mains "hot" wire for my printer's power supply.

There's a "right" version, if you want to put it in the upper-right corner of the lower table. Might be useful to have a second switch over there for the enclosure's lighting.

Print instructions

Licence: Creative Commons - Attribution - Non-Commercial - Share Alike Category: 3D Printer Accessories