P1P Magnetic Poop Chute Bucket

Magnetic Poop Chute Bucket
2
17
0
139
updated February 3, 2024

Description

PDF

I was looking for a Poop Chute for my P1P but couldn't find anything that didn't take ⅓ of a roll of filament. So I created this one. I believe this should also work for X1C and their respective sub models.

 

NEEDED MATERIALS:

About 100g of any filament

6 8x3 Neodymium Magnets (Could probably just use 2 magnets at the top end and put bottom on table)

 

OrcaSlicer says it takes about 95g of filament, and took a little over 2 hours to print laying on its back. Bridging is a little rough doing it this way, but its a tiny bit faster and it goes on the back of the printer so it doesn't have to look great.

Let me know if you want different versions or different files of it!

Tags



Model origin

The author marked this model as their own original creation.

License