Solder Flux Despenser Version 2

This is my second attempt to make a Solder Flux / Solder Paste Dispenser that is small, easy to print and easy to use.  

Hardware Required

M 2.5 2.5mm thick Brass Insert – M2.5 16mm Bolt – To attach the Lever to the Ratch Arm

2 times (M 3 4mm thick Brass Insert – M3 30mm Bolt) – To attach the Bracket to the Main Body

M4 4mm thick Brass Insert – M4 25mm Bolt – To attach the Lever to the Main Body

Note one side of the Rod is smooth.  This makes it easier to print and slide in the channel.

I printed at 75% fill, in ASA with no supports.