Tiny Whoop Hard Cases [Complete Set]

Hard Case for Tiny Whoops

Features:

• Protection - hard case (PLA/PETG) for 65mm tiny whoops
• Ergonomics - rounded edges with no corners, no more cuts during winter seasons
• Ease of use - the lid featured pull tab flanges for easier access
• Minimalistic - very slimmed down for portability, there are many cases with battery holder and spare props features but they are often waaay too bulky!

Changelog:

• [01/02/2024]
  • The canopy bump has now been widened with the frame height increased
• [10/01/2025]
  • Replaced the entire set with updated geometry for better lid fitment
• [29/01/2025]
  • Added 65P, 75, 75P and 85 sizes
• [30/01/2025]
  • Updated Print Files

Note:

• Combined - Main and Lid are in a single stl file, use "split to objects" function in your slicer to separate them
• Tiny_Whoop_Case_All.3mf contains 15 plates, with both combined and separated models on each plate.

Print Settings

• Filament material: PLA/PETG/Other rigid materials
• Layer height: Default or finer
• Wall Ordering: Outside to Inside
• Supports: Optional for the main case; Mandatory for the lid
• Infill: 20%
• Infill Pattern: Hexagonal/Tri-Hexagonal
• Nozzle Temp: 210-225°C
• Bed Temp: 55-65°C
• Print Speed: >100mm/s
• Rafts: Doesn't Matter
• Notes: Lay the main case on its rear and the lid on its flat surface,