eMMC to USB 2.0 adapter case

This is a case to fit the USB to eMMC adapter board at https://www.amazon.com/dp/B0BZK8N2YB

The case snaps together. If the board doesn't quite fit in the case, try shaving a bit off from the rear fingers.

The case is sized to fit both stacked and side by side USB ports.

Black case was made from recycled ABS, gray from Hatchbox PLA, and colored from Gizmo Dorks PLA. Chose not to make out of red to avoid bleed from the LED.

Print Settings

Printer Brand:

VoronDesign

Printer:

Rafts:

No

Supports:

Resolution:

0.1mm