Tape Measure Stopper for Lufkin

My slider no longer held the tape measure in place anymore so took out the broken one and copied and printed it.

May it help you.

Print settings

ABS

.25 layer height

5 walls

5 top/bottom

50% gyroid infill

Brim on

Supports on, zig zag 30% density, .2m top/bottom support distance

Print speed 40ms

Fans on 60% at layer 10 (I have an enclosure I let preheat before I start the actual print) I know people say not use use fans, for me it works, do what works for you.

Extruder temp 245

Bed temp 100

I'm sure PLA, PETG, would work just as well, I went with ABS since I'm comfortable with it(and that's what I had loaded and was too lazy to swap filament)