TELA | Table lamp E14 & E27 & E26 fast print

TELA | Table lamp E14 & E27 & E26 fast print

Give your space a radical modern and stylish vibe with this fast-print table lamp exploring 3D printing weaving techniques!

Any 3D printer can print it without exceptional print settings and a regular 0.4mm nozzle.
(See settings below)

The shade is made of 1 wall line following a wavy pattern.
It prints as fast as Vase-Mode (count 1.5h for the shade) but is mechanically much stronger thanks to the wave pattern.

This lamp works for E27, E26 and E14 socket screw thanks to a custom adapter you can easily clip on (STL file provided).

You can get the power cords from Amazon here:
For Europe:
E27 cord:  https://amzn.to/3OVrZjK
E14 cord:  https://amzn.to/3TchBqs

For the US:
E26/E27 cord:  https://amzn.to/3V5VYJB

Happy printing!

DIMENSIONS | Ø 120 mm x H 280 mm

PRINTING | Shade ~1.5h | Stand ~2h

Bulbe socket | E14 or E27 or E26

Lightbulb socket hole diameters:

• E14: Ø28mm
• E27: Ø41mm

UPDATES:
You can now pick between 2 versions of the shade and base.
The shade comes with the original weave of 0.5mm thick, and a new version with a weave thickness of 1mm. Same print settings for both.
To the original base (V2), I added a heavier version (V3) which weighs twice as much while only adding 20min to the printing time.
 

3D PRINTING SETTINGS

All 3 parts print upside-down.
(the STL files are already oriented properly)
The base prints with any of your favourite settings.
I added an extra version for the base for a tighter fit (file called “base_tight-fit”), as it seemed the fit between the base and the shade was a bit too loose for some people depending of the printer and filament type they used.
I printed the ones in the pictures with the original file (just called “base”) and it's tight enough.
So maybe start with that one first.

The only trick for the shade is to set the layer height to 0.3mm, since each weave line is 1.2mm thick, so is made of 4 layers.

For BambuLab users, turn on "Arachne" mode in the "Wall Generator" settings.
Otherwise Bambu Studio will detect some of the weave layers as empty.

SHADE:
The shade prints in standard mode, not in vase mode.
It prints upside-down, its head flat on the printing bed.
Layer height: 0.3mm
Wall line count: 2
top layers: 5
Bottom layers: 3
Build adhesion type: None
Supports: None
Infill: 15~20% (although there isn't any need for it)

BASE & ADAPTER:
The base must be printed upside-down, so with the round face for the E27 / E14 socket flat on the printing bed.
Infill: 20%
Wall line count: 2
top layers: 5
Bottom layers: 3
Layer height: 0.2mm or less
Build adhesion type: None
Supports: None