Cat fingersaver for heaters

Please, print only in heat resistant materials, PETG or above. Super please, check dimensions, I have added pictures so you can do this easier.

This piece is meant to avoid MochiZapata and NaraKnope safe, as they like to play and run over the heaters of the house, and we had fear of them knoking out the "cheap" pieces of plastic they sell to protect their fingers from getting stuck between the heater blades. Cost should be around 10ct per piece, so cheap and eficient, ours have been on for two months and none of this version have been knoked out. The small leaps are meant to be bended from pressure when pushed down so the piece doesn't move once in place.

It is meant to be printed upside down in angle from the top flat surface, there is a picture showing orientation in the slicer, this is in order to make the piece stronger and also so more pieces can be fit in a single print session.

Hope it helps.

Cheers