Sensor Housing indoor / outdoor DHT22 / and others

Case for dht22 on other sensor

• version outdoor with PG screw opening and cable stripe connector
• version indoor  with backwall cable opening 
• Used M2 8mm screws for lid
• M2x4x3,5 threaded inserts 
• PG7 screw connection for outdoor version
• DHT22 is connected with superglue to the housing
• Printed 20/ infill in PETG to resists outdoor conditions and print supports.

Take care to mount the lid with ventilating open downwards.

PG7 screw might cut a little on top, depends on vendor.