Wash Bottle Spout Cap
Description
PDFCap to fit the spout on 500mL wash bottles with integrated spout.
Print Settings
Printer Brand:
Solidoodle
Printer:
Solidoodle 4
No
Supports:
No
0.3mm layer height
Infill:
90%
Notes:
Print with Ninjaflex or similar so it can stretch (and is resistant to alcohol and acetone if required). I recommend erring on the side of over-extrusion to ensure an air-tight fit. I went 10% over my default setting.
Post-Printing
Note:
One connection hole is large than the other. Put that on first so it is trapped behind the smaller which snaps into the groove behind the spout connection.
Custom Section
One connection hole is large than the other. Put that on first so it is trapped behind the smaller which snaps into the groove behind the spout connection.
Disclaimer
Wash bottles are not recommended for long term storage. Even with these caps they might leak so I am not advocating using these for storage.
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.