CAT PIGGY BANK - NO SUPPORT REQUIRED

This model consists of two parts - the piggy bank and a cork for the bottom hole. Both pieces can be printed without any need of supports and the intended layer height for this print is 0.2 mm
Total print time is approximate 6 hours and it uses 65m filament.

Print dimensions are 18.7 cm * 13.5 cm * 13.8 cm (7.36 in * 5.31 in * 5.39 in)

DESIGN SPECIFICATIONS:

Cat Piggy Bank:

Print Dimensions: Height = 13.9 cm (5.47 Inches) | Base = 18.7 cm x 13.5 cm (7.36 Inches x 5.32 Inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 5 hours and 31 Minutes Amount of material required: ~ 58.5 m

Bolt for Cat Piggy Bank:

Print Dimensions: Height = 0.85 cm (0.34 Inches) | Diameter = 5 cm (1.97 Inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 18 Minutes Amount of material required: ~2.2 m

TOTAL PRINT TIME: 5 Hours and 49 Minutes
TOTAL PRINT MATERIAL: ~ 60.7 m