Pet Collar Hangar

I needed something to hold the training collars in my dog truck. This hanger is designed to be attached to a surface using rivets or screws. 

To make it printable without supports, I broke it into 4 pieces that screw into each other. Center Tube has to be printed twice. Screw the Connector into the female end of one Center Tube, then screw the other copy onto the free end of the Connector. Sides A and B go on the male ends of the Center Tube.

I printed it in PETG, at 0.2 mm layer height, 2 perimeters, 15% gyroid infill.

If you like what I'm doing…

 … consider buying me a coffee or joining my Club.