Curtain Clip - Blackout Assistance

A clip to hold your curtains closer to the wall and assist in preventing light from bleeding through around the curtain. One version with holes was specifically made for mounting to a tie-back that I have, so it might be a little specific to my purposes (unless you have a sold area to screw it into), but the version with no holes can be used with double-sided tape or Command strips (not sized specifically for them). Print in place hinge has .25MM tolerance, so may not move freely if your printer is not adjusted to be able to reach that tolerance. Cylindrical clasp is gapped to allow for fabric, so it does not snap tight without anything snapped in it, and this is as-designed.

EDIT: I have added a 3-piece design for users who have trouble with the print-in-place tolerances, though this is an untested model. Apologies that it took me so long to get around to this.

Category: Household