1/4” bit organizer for dewalt 8v cordless screwdriver

I wanted a way to store my dewalt 8v gyroscopic screwdriver and associated ¼” Bits so i made this holder.

holds both the driver and bits nicely The ¼‘‘ hex holes are a tad tight but after some use loosen up a bit. 

The driver side is not tight but doesn’t allow the driver to actually tip over easy to remove and replace and secure.

there are 57 ¼’’ bit spaces 3 rows of 10 and 3 offset rows of 9.

i printed this in Petg with 4 walls and 60%. Rectilinear infill you can print it in whatever and however you wont though I think any material and most settings would work fine.