Desk Stranding Switch Adapter

I had already printed the main body of Nils Kal's Desk Stranding model before realizing I didn't have any big switches that would fit the cutout, but I did have a bunch of smaller switches.  This adapter plate makes those fit into the original cutout and adds some aesthetics that try to align with the original creator's.

This was a pretty tight fit and I printed at 0.1mm layer height to try and get some definition around the locking features though probably not necessary.  Prints flat on the outer face with no supports.

I don't remember the exact part number but the switch I used has a body roughly 8.4mm x 13.5mm which is what the cutout here is sized for.

Addition of an adapter plate for the on/off switch in the main body to fit the switches I had on hand.