YARBM (Yet Another Ryobi Battery Mount)

Yet Another Ryobi Battery Mount. Now supported by pegboard!

As if you didn't already have enough printed Ryobi accessories in your garage.

Printing Notes:

I printed with PLA and default settings (2-wall, 15% infill) and am very satisfied with the results. I rotated the model to sit on the honeycomb side to prevent layering from creating a fracture point where I would expect the bending moment to be the greatest. 

Development Notes:

This model is in the testing phase; however, this is holding an 18v battery in my garage right now.

Mounting points for screws have been replaced by curved and straight pegs for 1" pegboard. The skeleton-style has also been replaced with a partial honeycomb pattern.