Moon Tall Light & Tea Light Candle Holder

Inspired by Skelei's moon candle holder - I wanted one that fit both tea lights and tall candles.

Depending on your slicer, you will likely have to scale up. Perhaps by:

1000% to 1050%

(Depending on your slicer settings, and the diameter of your candles)

You may want to consider widening the fit-hole for tall-candles. I wanted a press fit, and the gentle taper allows some variance - but I think most tall candles would prefer some more space.

Note that these are designed for SLA resin printing, and a portion is hollowed out, for a more stable center of mass.

I glued mine to some mason jar covers - just to give them a more sturdy base. If you are using tall-candles with this, I encourage you to do the same.

Fire safety is important, don't do anything haphazardous!

(I would've sized them larger, but I have to fit them into an elegoo mars footprint. I can squeeze two side-by-side, just barley, printed directly on the bed)

Thank you again to Skelei for sharing their original design!