I have designed this thing because I could not find anything on here for me to print. I get annoyed when I have to try and find a place to put my phone while using my laptop anywhere but a table. This eliminates the need to worry about that. It tilts up and down and left and right. I have not put rotation in to the design. I may change it at some point. the hanger for the laptop part is over sized for my laptop so that I could attach some soft adhesive backed feet to the inside so that it does not scratch the laptop. The thickness of my screen is 9mm for my Sony VAIO flip 15. It works well with a thinner asus Vivotab 11.6 as well. So it should work for many other laptops. If not, I will upload different backs to conform to other sizes if needed. The back piece is interchangeable so that I could just redesign that one part. I may make it mechanically adjustable at some point. But I get bored too easy and mov e on to the next project.
I printed with supports and at 10% infill and .2 layer height. Worked well with a little to clean out. Because I printed with such little plastic, I brushed the ABS with acetone to make sure it stayed together.
You will need 2 3mm x 25mm screws and wing-nuts to tighten. that's what I used, but you could use whatever you feel like on your print.
The front is designed to only go down enough to be parallel with the screen, but can adjust up and to the left and right to compensate for light reflections.
Category: Mobile PhoneThe author marked this model as their own original creation. Imported from Thingiverse.