Pen Stand - Microsoft Surface Pen 4 or pretty much any other pen

I needed a stand for my pen. I wanted one that could be situated so that picking it up and placing it back in was as close to my neutral hand position as possible while being able to sit it next to my laptop. It also had to be small enough to carry in my bag.

I printed it at .2mm layer height and 20% rectilinear infill. The print I have pictures of is using Verbatim clear ABS. I might modify it to hold an extra battery and possibly the pen tip container that comes with the Surface pen 4. I will leave all of the models for download if I do that.

Print Settings

Rafts:

No

Supports:

No

Resolution:

.2mm

Infill:

20%

Notes:

I use a brim with the offset set to 0mm and do 5 passes at one layer thick. The thin end wants to pull up from the bed, so I might add some hold down pads to prevent it from pulling up from the bed.