Sailor Moon Baby Rattle

I designed & printed this Sailor Moon baby rattle for my niece, and wanted to share it with other fans.

Layer height: 0.2 or 0.12

Infill: 10 - 25% for everything but the Moon.  

Supports: the Moon, Pommel, and Hilt need a small amount of support.

Rattle: For the moon, I used a grid infill pattern at 5%. I recommend adding a few extra walls to help with durability (in case the child throws, drops, or hits the wand on things). I stopped the print toward the top - after the connector peg, but before the top layers (see picture).  At this point, you would fill the infill openings partially with rice (or beans, beads, etc.) to make the rattle. Then, resume the print to seal the rice inside.

Assembly: I connected all the pieces with PLA Goop, but super glue or hot glue would probably work well too.  

Enjoy! :)