Matek R24-P6 ELRS PWM receiver case

Adapted from jmxp69's design from thingiverse this case protects the board of the receiver and gives a flat surface on the rear for mounting within a model.

Screw holes are sized for M3 screws and require tapping

print the body of the case standing up from the antenna cut-out, no supports needed 

I have taken this design by jmxp69 from thingiverse and remixed removing the holder for the antenna and making the receiver slot into the case with a screw fixed lid so that you can have a flat surface on the underside to use velcro or sticky pads to mount inside an airplane or other model.