PCB holder

Works perfectly. The top cap must have a very thin layer at the start of the thread as this doesn’t print properly. That doesn’t have any impact on the print though.

Works great! Printed out 2 for easier work with PCBs. (edited)

Love the spring design

Thanks for the awesome design.
I printed a couple in Sunlu orange matt PETG and they came out perfectly.
Thanks again for the effort you put into designing this

Works great! I found one to be good enough for most small boards.

very useful model, tolerances where a bit tight for my printer, but a few seconds with a file and a dab of silicone grease got it working well.

printed on Creality k1 with Sunlu PETG

What about a magnet in the bottom and finding a suitable metal plate?

Very good model,
Easy to print without support or brim

This is such a handy little holder and the printed spring is genius. I printed this in ASA at 0.15mm layer height with a 0.2mm nozzle and no supports. Thanks for sharing your design.

Printed on Qidi Q1 Pro in PETG without support, 15% infill and 0.2mm layer height.

Really nice idea/design with the 3d printed spring. Works perfect.