Masterspool V5 RMX-Small

I modified the model to fit my self-made filament holder by reducing its height by round about 7mm. I also removed the logo from original model, for easyer printing.

Print settings

infill : 10%
infill : Adaptive Cube
Material : Recyled PETG ( or any kind of PETG suggested ) 

How to use ?
when you got your refill you slide it on the big part , then you screw the small part to it
before you open it , see if you can grab the end of the filament that is on the inside of the refil spool
put that part into the hole that is on the spools in the middle , both sides are fine depending where the end is located
then release the zipties and enjoy printing

Spects
Spool size : 197.77 mm
Spool Height : 62 mm
Spool inside diameter : 79.89 mm

Enjoy my model? Show some kitty love 😸💖 by downloading, liking, and sharing a pic of your make. Your cat will thank you with extra purrs! 😻 If you don't have a cat, share your makes anyway — my cat will do the purring for you! 🙏🐱

• changed the high from 69,78 mm to 62 mm
• removed logo, for easyer printing.