ESP32 38 pin breakout board case (snap-fit lid)

Designed this case with a snap-fit lid to fit a 38 pin ESP32 breakout board, you'll find these all over aliexpress/ebay/amazon, etc. 

The case has symmetrical cutouts to access the terminals on either side, so you can mount the board in any orientation. You should also be able to access the usb-c/micro-usb port whilst the lid is off, without needing to remove the board from the case. The board can be screwed into the case leveraging some heat set inserts and 4 bolts.

I am personally using this mounted with some double-sided 3M VHB tape.

Required hardware:

• Heat set inserts: M3 x L6 x D4. Maximum length can be 7mm, this is just what I used.
• 4 x bolts: M3 x 8mm
• Optionally, some double-sided tape to mount it.

Printed this model? Show the community what it looks like by posting your make.

Like this model?