Multiboard tool holders

Setting up my Multiboard I was not able to find any toolholders that fit for the tools I want to use it for, but I found a very good gridfinity shelf made by user David D here on Printables that had a nice and stable way of hanging on to the Multiboard. So I remixed by removing the gridfinity holder, sometime streching the model a bit and creating tool holders and screwdriver holders that fit my need. Also did a couple of versions that I hope are generic enough to fit for others. Will try to update with more versions after some more testing.

Note that you need some multiconnect connectors to fit these to your Multiboard: https://www.printables.com/model/716558-multiconnect-general-connector-for-your-board

I normally fit 2 of them to each holder.

Screwdriver Holder:

I have a lot of screwdrivers from many manufacturers. These holders are based on some of them, but I found that most other screwdrivers with different types of handles will fit ok as well. Normally I find that in screwdriver sets, handles are “one size” and maybe there are one or two in a set that are a bit smaller. So I made the holder so that there can be one or two small ones and three or four bigger ones. You will see in naming that they named 1+3, 2+4 etc where the first number is holder for a smaller screwdriver. Also did a couple of variations on the hole size since i found some flatheads can be a bit bigger than the rest.

Generic Tool Holder:

The generic tool holder was made for some torx tools I have, but I found that several other tools can use that kind of holder as well. The torx tools only needed a slot of 6.5mm, but most others needed a bit bigger, so I also made them with 8.5mm slots. And since I found some tools that were even bigger but would also fit, I made a version where two of the slots are 10mm.

Removed the gridfinity holder and designed tool holders in it's place.