"The Armchair" Fantasy Sports Trophy Base Extender

Do you have a perpetual Fantasy Sports Trophy that has run out of spaces for new champions? Don't but a new base, print one!

This base has been designed to fit "The Armchair" Fantasy Football Trophy from Fantasyjocks.com. It has 5 sections that will fit 15 total 2.655" x 0.8" engraved plaques so you can keep adding champions. The largest side has the option of a 140 x 65 mm plaque, or two more sections that will fit 6 total 2.655" x 0.8" engraved plaques. The tolerances are pretty tight, so print at a decent resolution, and increase scale to 101% if necessary.

There is a hole through the center of the base to run a threaded rod if you didn't want to glue your trophy to the base.

Also in this post are files for printable plaques. Just use TinkerCAD to type your team names in it, change the font to hole, and print. You can even switch color halfway throughtto make it mimic an engraved plaque.

The dimensions of both plaques are 2.0 mm x 20.3 mm x 60.7 mm and should fit into the slots of the base. The "Tiered Plaque" has a slightly smaller rectangle on top of a larger rectangle. The "Normal Plaque" is just a flat 2 mm thick plaque to print on.