Anycubic Kobra / Kobra 2 / Kobra 2 Pro - Toolbox 06

Anycubic Kobra / Kobra 2 / Kobra 2 Pro - Toolbox 06

Toolbox with two drawer and top 

The drawers has indexing in the closed and open position.

To install this accessory, it is not necessary to remove anything from the printer. 

Simply place on the upper channel of the printer profile, and pressed until it clicks.

In version 02, I modified the offset that the top “tooth” to be smaller, taking into account Darian's advice. 

I reduced the size of the the lower “tooth” for easyer installation.

Version 03 - updated to fit in any positions (left and right ) for all Kobra 2 Series

You can see how the new grip of this new version looks in the capture from this post.

Before printing this toolbox, I recommend you do a test print, regarding the offset between 2 pieces. Please analyze the dimensions between the compartment where the drawer fits and the drawer (see picture)

Printing parameters for both :

Layer height : 0.2

Perimeters : 3

Solid layers : 4

Infill : 15%

Support : YES  - only for main body

Brim : Outer brim only 10 mm

Material : PLA

Printer : Anycubic Kobra 2 Pro

You can check my other toolboxes :

https://www.printables.com/model/707806-anycubic-kobra-kobra-2-kobra-2-pro-toolbox 

https://www.printables.com/model/729540-anycubic-kobra-kobra-2-kobra-2-pro-toolbox-02

https://www.printables.com/model/733765-anycubic-kobra-kobra-2-kobra-2-pro-toolbox-03

https://www.printables.com/model/736226-anycubic-kobra-kobra-2-kobra-2-pro-toolbox-04 

https://www.printables.com/model/736606-anycubic-kobra-kobra-2-kobra-2-pro-toolbox-05 

https://www.printables.com/model/741401-anycubic-kobra-kobra-2-kobra-2-pro-toolbox-07 

If you print this accesories please share your make, leave a review, and drop a like.