Robust Filament Spool Holder

Printed on a Průša XL printer. For smaller printing areas, the "Lower part" can be divided into two parts.
Dimensiones of the table are 60 cm x 46 cm. If the width of the table is greater than 46 cm, simply extend the "Bar" part.

For higher strength, I recommend printing with at least 3 perimeters (I printed with 4).

Glue is required for assembly. The upper part needs to be glued to the lower part. The rod is again made of two parts that need to be glued together. Then screw both parts to the table.

Place the "Filament protector" part on the top edge of the printer (Prusa MK2, MK3, MK4) to prevent the filament from rubbing against the metal.