Pac-Man Keycaps

I wanted a good keycap for my keycap fidgets - this model looks awesome, and I made the icons on a tilt to give them a bit of extra tactile feedback. 

Printing Instructions: 

1 - I like to print with these with a variable layer height, with the keycap at .3mm and the icons at .1mm. 

Any infill is fine.  

If you want the two-colored effect, you will need to add a pause to your print to swap out the color. It looks best if you wait until the entire base is printed so only the icons are color-swapped. 

1 - I removed the pacman icons and added them to individual keys, rather then in a spacebar.

2 - The keycaps are based on https://www.printables.com/model/397883-cherry-mx-compatible-flat-top-keycap-fdm-optimised. I added supports to the underside of the keycaps. The original model was prone to have the part that connected the keycap to the switch fall off.