Vesa 100 Monitor Honeycomb Wall Mount

VESA 100 mount for HSW

Use the M4 inserts with a nut to connect the mount to the board (insert M4 is from the official HSW project and included for convenience)

I printed the Monitor attachment (unchanged from the initial project) vertically with the thick side on the bottom. 

I printed the wall attachment flat on its back. It should also be printable vertically.

Only print this if you feel confident you can make it strong enough. I feel good about the strength of my print using Bambu Lab PLA-CF. Use higher walls and infill for strength.

While uploading this I realized that the mount could probably 4 honeycombs tall instead of 5, but I don't plan to change this.

Changes the position of the mount holes to line up with the honeycomb storage wall dimensions