Elegoo Mercury Plus Wash & Cure Cover Handle

Not really a remix, but I took inspiration from the Mars/Pro Cover Handle and designed this one from scratch. It works essentially the same way, and provides a slot so that the various hanging accessories can be installed or removed while the cover is hanging off the back.

NOTE #1 - That example print is ultra-crappy looking because it was printed with home-made filament run through a 1mm nozzle. That filament had a diameter range between 2mm and 1.4mm, so extrusion simply cannot be consistent. I have been recycling print scrap into filament, and this kind of thing is the perfect way to use it while I work on getting it more consistent. :)

Note #2 - Due to the above, this has a lot of allowance for crappy prints. With good filament, it will probably be on the loose side, but should still work just fine. But, that's why I included the STEP and F3D files, so anyone is welcome to grab it and adjust as needed.

note 3 - I glued the two pieces together using gorilla glue, and attached it to the cover using Command strips of double sided tape, so I can always remove and reprint it, or replace with a better solution without damaging the cover at all.

Enjoy!