Filament Spool Adapter (to stop rocking) with Stopper, for CR10-SE to stop spool from sliding off
Original Adapter, plus End Stop Ring, to keep spool from drifting off. This was needed on my CR10-SE
10
94
0
652
updated January 25, 2024
Description
PDFEnd-Stop ring, to keep the spool on the adapter. (Pic 3, is what happened without it)
Print the adapter upright, with NO SUPPORTS. (also, the ring, of course).
I printed in PLA on a CR10-SE, and PET-G on a P1S. Both work fine.
I used 3 walls, 15% infill.
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
The original model is excellent. It will fit your Enders, CR-10s, Clones, and more. However, my spools were drifting, on my CR10-SE, and comming off the adapter, at the arm end. They would end up diagonal, and dragging as they turn. If this happens to you, add this stopper.
Ender, the END STOP. Print this ring, slide it on 1st, then slide on the adapter. Both will JUST fit, and it will turn freely. Be sure the adapter snaps on.
