Prusa MK3 leg adapters for taller rubber feet

I needed to raise my Prusa MK3S higher off the table to accommodate a touchscreen in the front panel (and even without it, it was sitting a bit low on my not-totally-flat table), so I made adapters for these furniture rubbber feet
https://www.amazon.com/gp/product/B00S4BY88W/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1

Print 4 of them, insert M5 bolts into the slots, use M5 screws to attach to the rubber legs, then insert into the extrusions and turn 90deg - same as the original feet.

Print in TPU/Flex. Orient on build plate with the screw insert slot facing up. Supports are only needed for the tab coming off the top (the one that will insert into the extrusion).

Print instructions

Resolution: 0.2mm
Infill: 50%
Filament: TPU/FLEX

Orient with screw insert slot facing up. Supports only needed for the tab coming off the top (the one that will insert into the extrusion). In Prusa Slicer I set support interface spacing to 0.6mm and it came off pretty easily. Also recommend checking "Avoid crossing perimeters" setting.