Fysetc ERB Sturdy Bunny / ERCFv2 2020 Electronics Enclosure

This is a small slightly oversized case that mounts on the bottom of the 2020 profile of the Sturdybunny / ERCF v2 below the filament blocks at the back.

Features

• Accurate USB-C & Power Pass through holes.
• Left and Right passthroughs at the top for feeding in wiring.
• Plenty of ventilation in the lid for air flow.
• Plenty of height to accomodate the ERB, possibly the Easy BRD too (Heatsinks dependant).
• Countersunk screw heads in the lid to allow flush fitting.
• 2x Additional corner supports to prevent the board bending.
• Additional space within the enclosure for wiring bundles.
• Height sits perfectly to act as a foot for the ERCF v2 and make it sit stable against the surface (if mounted flat).

BOM
7x M3 Brass inserts
7x M3x6mm Screws
3x M3x16mm Screws + M3 T-Nuts

Printing
Main enclosure will need a small bit of support on the mounting tab.
Lid will need to be printed upside down.