Ender Switchwire underglow

This is a LED channel that can be mounted on the bottom panel of the Switchwire (Enderwire). You need a transparent bottom panel of course. Use the “template” to drill the holes into the bottom panel!

There is a small gap where the two halves meet unless you drill the hole perfectly.

Parts needed:
- WS2812 strips
- 3-Pin JST connector  for end
- Standard voron heatset inserts M3
- M3 counter sunk screws 8mm

The “channel” part needs to be printed in dual color: transparent on the bottom and black for the rest. The “reflector” should be white. Do not use PLA, it might get too warm with the LEDs. I used PETG for the reflector and bottom of the channel and ABS for the rest.

I installed mine on stream: